True Fitness ES900 Owner's Manual page 19

CHAPTER 2: ASSEMBLY INSTRUCTIONS
TREADMILL ASSEMBLY STEPS (continued):
Step 3-2A Frame Cable Connections:
*TOUCHSCREEN CONSOLES & 15" TFT CONSOLES ONLY
Picture 3-2A-1
Cut Wire Tie
Picture 3-2A-2
Connection Made
Picture 3-2A-3
a) Place Auxiliary Power Supply (included in console box), in
b) Connect TCPS Power Supply AC connector (large
c) Secure Auxiliary Power Supply to floor using the supplied
d) Separate the AUXPS cables that are attached to the CTRL
e) Connect the female end of the AUXPS Cable coming from
Truefitness.com / 800.426.6570 / 636.272.7100
motor area floor location shown in picture 3-2A-1
connector w/ 3 pins) into Auxiliary Power Supply as shown
in picture. Make sure connector is fully inserted.
wire ties.
cable and cut the wire tie holding the female end of the
AUXPS cable to the CTRL cable as shown in picture 3-2A-2
Pedestal to AUXPS Power Supply Cable. See picture 3-2A-3
NOTE: The male end of the AUXPS cable wire tied to the
CNTRL cable is not used for this installation.
15