True Fitness ES900 Owner's Manual page 23

CHAPTER 2: ASSEMBLY INSTRUCTIONS
TREADMILL ASSEMBLY STEPS (continued):
Step 4 Pedestal Hardware and Motor Cover:
a) Rotate Pedestal – R (D) upright as shown in Fig 4.
b) Using 5/16 inch hex key, install, but do not tighten, two per side of Bolt 3/8-16 UNC x 5-1/2 (b) and Washer 3/8
Split (a) into front of Frame as shown in Fig. 4.
c) Remove ribs (right and left side) on Motor Cover as indicated by arrow in Fig. 4-1. Discard tabs.
NOTE: Hold inner portion of motor cover shown on right side of Fig. 4-1. Wiggle left side up and down until
tab breaks on right side. Then grasp tab and wiggle until it breaks free. Repeat for right side of motor cover.
d) Install Motor Cover using hardware; flat washer (n), screw (o), and then Cap – Motor Cover (p ).
Fig. 4
Truefitness.com / 800.426.6570 / 636.272.7100 19