Changing The Remote Escape Character - Multitech MULTI MODEM II MT5600BL User Manual

MultiModemII User Guide
3. To change the password, press á ß or â to select the first character of the pass-
4. To cancel the new password, press à until the password is erased. To save the

Changing the Remote Escape Character

To improve security, you can change a remote modem's remote configuration es-
cape character. The remote configuration escape character is stored in register S13.
The factory default is 42, which is the ASCII code for the asterisk character (*). Set-
ting S13 to 0 (zero) disables remote configuration entirely—but if you do this re-
motely, you won't be able to change it back remotely!
1. Establish a remote configuration link with the remote modem as described in
2. Type ATS13=n, where n is the ASCII code for the new remote configuration es-
3. Save the new value by typing AT&W and pressing E
4. Type ATO<CR> to exit remote configuration.
word, and then press à to go to the next character. Repeat until you have entered
the entire password.
new password, press the Enter button. The next time you remotely configure the
modem you must use the new password.
"Basic Procedure."
cape character, and then press E
5 Remote Configuration
.
NTER
NTER
.
58