Calling Procedure - Multitech MULTI MODEM II MT5600BL User Manual

MultiModemII User Guide
7. Press the Enter button again to go to the CALLBACK NUMBER screen.
8. Press à, à to go to the ENTER NUMBER #2? screen.
9. Repeat steps 3–7 to enter the next number.
10. Repeat as many times as necessary, up to memory location 30, until all numbers
Warning: There is no way to review an entry to confirm that it has been entered cor-
rectly. If you attempt to look at a number entry by pressing the Enter button for an
ENTER NUMBER #n? screen, it is possible for you to accidentally erase the entry.

Calling Procedure

Use the following procedure to call a modem that has callback security enabled.
Note: Autoanswer must be enabled on the calling modem (S0=1 or S0=2).
1. Using a data communication program such as HyperTerminal, dial the number
2. When the connection is established, the callback modem responds with a re-
3. Type the password for your modem, and then press E
4. If the password is valid, the callback modem disconnects. Then, after a short
Note: If you are calling a direct connect number, you must append a hyphen (-) to
the password. If the corresponding phone number has - as its first character, you
will be able to go directly online with the callback modem. If the corresponding
phone number has no - character, you will be prompted for a different password.
have been entered.
of the callback modem.
quest for a password.
tempts to enter a valid password or be disconnected.
delay, it calls the number associated with the password and establishes a work-
ing connection.
6 Callback Security
. You have three at-
NTER
63