Section 5: Installing The Flap Servos - Hangar 9 Cessna 182 Skylane Assembly Manual

Section 5: Installing the Flap Servos

Parts Needed
• Wing panel assembly (right and left)
• Flap servos with mounting hardware (2)
(JRPS537 or equivalent)
• Servo mounting blocks (4)
• Long half servo arm (JRPA212)
Tools and Adhesives Needed
• Thin CA
• Thick CA
• Drill
• Drill Bit: 1/16"
• Felt-tipped pen/pencil
• #2 Phillips screwdriver
• Triangle
• Straight edge
Step 1
Locate the flap servo hatch on the bottom of the wing and
remove the hatch from the wing.
Note: The flap servo will be mounted to the hatch.
Step 2
Locate the flap horn attached to the flap and use a straight edge
to project a line forward 90-degrees to the flap hinge line as
shown. Mark the edges of the servo opening.
Step 2 photo
Step 3
Replace the hatch and mark the edge of the hatch. Remove the
hatch and draw a line on the inside of the hatch connecting the
two marks on the edge of the hatch. Also mark the hatch so you
know which edge is the forward edge.
Continued
13