Hangar 9 Cessna 182 Skylane Assembly Manual page 20

Section 7: Mounting the Wing to the
Step 8
Mount the strut to the bottom of the wing using a 4-40 x 3/4"
cap screw. Next, slide the strut fairing onto the strut and drill a
hole at the cap screw location. Make the hole large enough to
allow the screw to be removed.
Step 9
Mark the location of the fuselage mounting hole and drill the
strut using the same method as in Step 8. Slide the other
fairing (curved to match the fuselage) onto the strut and secure
the strut in place with the 4-40 screw provided. Drill a hole to
access the mounting screw as done previously.
20
Fuselage
Step 10
Secure the fairings to the wing and fuselage using 30-minute
epoxy. Hold the fairings in place with masking tape and allow
the epoxy to cure.
Step 11
Repeat the previous steps for the other wing strut installation.
Note: You will need to reinstall the wings during
the installation of the horizontal stabilizer.
Continued
Step 10 photo