Hangar 9 Cessna 182 Skylane Assembly Manual page 12

Section 4: Installing the Aileron Horn
Step 4
With the mounting hole locations marked, drill the holes for the
mounting screws using a 1/16" drill bit. Be sure to drill straight
through the aileron at a 90-degree angle to the flat work surface
not to the surface of the aileron.
Step 5
Using a small Phillips screwdriver, attach the control horn
using the provided hardware.
12
and Control Linkage
Step 6
Locate the aileron control wire (threaded on both ends) and
thread a 4-40 locknut and clevis a minimum of 12 turns onto
each end. Attach one clevis to the outer hole in the servo arm.
With the aileron at neutral and aileron servo electronically
centered, adjust the length of the control wire and attach the
other clevis to the middle hole in the control horn. Secure the
locknuts against the clevis to keep the wire from rotating
and coming loose.
Step 7
Repeat the previous steps for the opposite aileron horn
and linkage.
Continued