Hangar 9 Cessna 182 Skylane Assembly Manual page 38

Section 15: Mounting the Engine
Step 4
Carefully drill the four mounting hole locations in the firewall
using a 3/16" bit.
Step 5
Install the blind nuts into the holes by first pressing them
in place with your finger and then seating them using the
mounting plate and screwdriver as shown. Place a few drops
of thin CA on the backside of the nuts to secure them in place,
making sure not to get any glue on the threads.
Step 6
Secure the mounting plate back onto the engine using the
same screws you removed in Step 1. Use threadlock on the
threads to prevent them from backing out. Mount the engine
using the 3/4" standoffs 8-32 screws and washers.
38
Step 7
Install the recommended servo hardware (grommets and
eyelets) supplied with your radio system onto the throttle servo.
If using a gas engine mount the servo into the servo mount as
shown. Drill 1/16" pilot holes at the mounting screw locations.
If using a glow engine, mount the servo from the inside of the
motor box. Drill a hole in the firewall for the linkage to pass
through to the carburetor.
Continued
Step 6 photo
Step 6 photo