Fisher & Paykel DishDrawer DD24D 7 Installation Instructions Manual page 5

Q OPTIONALLY HARD
_ REMOVE THE LOWER DRAWER
WIRING PRIOR TO INSTALLATION
REMOVE THE ACCESS COVER & POWER CORD
Access
cover
/
To prevent kinked hoses, we recommend
rotating the drawer anti-clockwise and
resting it on its side after removal.
Press the release tabs in on
either side and push back
to release drawer from
runners.
TERMINATE THE WIRING AS SHOWN
Remove knock-out for cable clamp and
fit a suitable cable clamp for the conduit.
\\
Use copper conductors only.
Electrical Shock Hazard
Before continuing, ensure that the product is
disconnected from the power supply.
Failure to follow this warning may result in
electrical shock, injury or fire.
\\
REFIT THE DRAWER ONTO THE RUNNERS & CLOSE
Ensure the drawer
is now rotated
tabs
, release clockwise back.
;'(1O0ram)
Before refitting the drawer,
ensure the hoses are not
twisted and the latches at
the rear of each drawer
runner are facing forward.
Ensure the release tabs on
both sides are reset fully.