Fisher & Paykel DishDrawer DD24D 7 Installation Instructions Manual page 13

(_ SECURE TO THE CABINETRY ON THE SIDES
Open the
drawer halfway.
Using a fiat-bladed
Using a small Philips
screwdriver,
screw through the trim
moulding, securing the
side mounting bracket
to the cabinetry.
Do not damage the
rubber trimseal.
Repeat for all
four brackets.
Replace the gray
rubber plug back into
the trim moulding
and ensure the trim
seal is facing forward.
@
OPTIONALLY SECURE TO THE CABINETRY ABOVE
13
x2)
The top mounting
brackets will only bend
upwards a maximum
of 3/8"(10 mm).
@
FIT THE SUPPLIED TOEKlCK PANEL
(OPTIONAL
FORINTEGRATED
M ODELS)
Where the toekick
meets the bottom
ofthetubis the
cut-off point
Moun ring rail
Lay the toekick fac'e down on
a chopping board or simlllar
Turn the toekick over and
score along the same line
Smooth the edge with a file.
Be careful of sharp edges.
)oint
a pencil
Score along with a knife Gently snap off the excess
Snap off the two end tabs
Slide the toeklck onto
the mounting rails
either side and screw
the toekick onto the
bottom of tub on
either side.
Importand
Do not overtighten screw.