Linkage Rear Suspension - Beta EVO 2T Owner's Handbook Manual

4

LINKAGE REAR SUSPENSION

To guarantee an optimal operation and the 45Nm
longest lifetime of the progressive linkage
of the rear suspension, it is recommended
to check after every race/run the correct
tightening of the bolt.
Verify that the result of the suspension bolts
to specified torque.
30Nm
45Nm
To check the upper shock absorber fasten-
2,5Nm
ing proceed as follow:
2
Remove screws 1 and 2 (two per side).
Remove the mudguard.
At the end refit the screws 1 and 2.
Tighten to the torque indicated.
2,5Nm 1
NOTE: It is recommended not to wash with
water jets at high pressure in the zone of
the linkage.
Perform the check according to the times
indicated in the table on page 61.
To verify device, contact authorised Beta-
motor customer service.
GB
53