Bleeding The Rear Brake - Beta EVO 2T Owner's Handbook Manual

Hide thumbs Also See for EVO 2T:
Table of Contents

Advertisement

WARNING:
The brake fluid is extremely corro-
sive. Take care not to spill it on the
paintwork.
Wear appropriate protective cloth-
ing and protection gloves.
Keep coolant out of reach of chil-
dren.
WARNING:
Avoid any direct con-
tact of the liquid with skin, eyes or
clothing. If this happens:
- with the eyes, rinse immediately with
plenty of water and seek medical advice.
- with skin, immediately clean contaminat-
ed areas with soap and water. Change
clothing that is contaminated with liquid.
If liquid is swallowed, contact a doctor
immediately.

BLEEDING THE REAR BRAKE

To bleed air from the rear brake circuit,
proceed as follows:
• Remove the rubber cap 1 from the valve
2.
• Open the sump cap.
• Insert one end of a transparent tube into
a container.
• Pump with the brake lever 2/3 times
and keep the lever pressed.
• Unscrew the valve and let the oil drain.
• If are still visible in the tube repeat above
operation until obtaining a continuous
outflow of oil within no air bubbles.
• Close the valve and release the lever.
1
2
45
4
GB

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents