During Printing - Xerox Document Centre 706 Series User Manual

14.3 On Using TCP/IP (LPD) 13.12 System/Meter Settings
When LPD Spool is set to Off (non-spool mode)
14.3.3

During printing

When LPD Spool is set to Hard Disk or Memory (spool mode)
When LPD Spool is set to Off (non-spool mode)
When the IP address or computer name is changed
204
Some client computers may re-send immediately when the print data has exceeded
the receiving capacity. When this occurs, the client computer appears as if it has
crashed. To rectify this situation, the client computer must be stopped from sending
print data.
The function to stop/eject print data spooled to the printer spool can be set up from the
control panel. Refer to "3.3 Cancelling Printing from Printer" and "3.4 Forced Out-
putting" for information on the setup method.