golmar SV-372S Colour Instruction Manual page 10

MONITOR DESCRIPTION
F
unction push buttons.
Push button to stablish / finish communication or intercom function (only available on systems
with 2 or more monitors, for description and connection see page 48 & 51).
In configuration menu mode
selected option, (see page 49).
Push button for a
door paneI during 90 seconds (if exists more than one door panel, pushing each time, the
picture and audio will switch from a door panel to the other one), to establish audio and
video communication with the door panel
last for 90 seconds or until press
In configuration menu mode
selected option, (see page 49).
Push button to activate the lock release. During call reception, communication and
autoswitch-on processes, it allows lock release activation. During activation, the picture
will disappear from the monitor screen.
In configuration menu mode
Push button to activate the auxiliary device. D
autoswitch-on processes
Push button to enter / exit the configuration menu mode (see page 49).
S
witch 'end of line resistor'.
The switch 'end of line resistor' is located
monitor . S et to ON the
only for intermediate monitors
*Factory default
: To scroll up through the menu or to increase the value of the
utoswitch-on. It allows to visualize the picture and to listen the audio with the
push button monitor again.
: To scroll down through the menu or to decrease the value of the
: Select / deselect the desired option, (see page 49).
, activate the auxiliary device (see page 52).
at the left side of the back of the
monitor where bus wires terminate, placed to OFF
.
press push button. The communication will
uring call reception, communication and
9