Install Wire Into The Welding Gun - Firepower FP-125 Operating Manual

INSTALLATION

3.12 Install Wire into the Welding Gun

1. Plug the Welding Power Source into the 120VAC
receptacle for the FirePower FP-125 and FP-135,
and into the 230VAC receptacle for the FirePower
FP-165.
ELECTRIC SHOCK CAN KILL! With the gun
switch (located on the gun) activated, weld-
ing power is applied to the output terminals,
feedroll, ground clamp, gun cable connection
and welding wire. Do not touch these parts
with the gun switch activated.
2. Turn the welding machine ON with the front panel
Voltage Control Switch set to "1".
Wire Feed
Speed
FINE COARSE
v
1 LOW
Voltage Control
Switch
2 HIGH
Figure 3--12: FP-125 Power ON
Wire Feed
Speed
Voltage Control
Switch
Figure 3--13: FP-135, 165 Power ON
Installation
WARNING
Art # A-09061
Power ON
OFF Switch
Power ON
OFF Switch
Art # A-09062
FIREpOwER Fp-125, 135, 165
3. Set the wire feed speed to half-way or "5".
Wire Feed
Speed
FINE
v
1
Voltage Control
Switch
2
Figure 3-14: FP-125 Wire Speed Half-way
Wire Feed
Speed
Voltage Control
Switch
Figure 3-15: FP-135, 165 Wire Speed Half-way
3-9
Art # A-09061
COARSE
Power ON
LOW
OFF Switch
HIGH
Power ON
OFF Switch
Art # A-09062
Manual 0-5123