SoftBank 706N User Manual page 46

Table of Contents

Advertisement

• If the battery or charger becomes extremely hot during charging. Stop
charging immediately and contact Customer Service (zp.19-43).
1
• If too many devices are inserted in the socket, it may cause
overheating and result in fire.
• When the battery level runs out quickly, replace it with a new one
before charging.
• Lithium-ion batteries are valuable and recyclable resources.
• Do not dispose of batteries as municipal waste. Insulate the terminals
with tape and bring them to a collection point for recycling batteries or
to a SoftBank Shop. Dispose of batteries separately beforehand
according to local regulations.
• The battery pack may swell slightly as the life comes close to the end
and it causes no problem.
1-14
Note
Use only approved battery and charging device (zp.i).
Insert the battery into the handset before charging. The handset
cannot be charged and powered on without the battery.
The lamp blinking in red during charging indicates battery failure.
Contact Customer Service (zp.19-43).
If "Check the power supply immediately. Problem with charging
voltage." appears on the Display, turn the handset off and remove the
battery from the handset. Then, recharge the battery. If charging fails
again, contact Customer Service (
Unplug the charger from the electrical socket or cigarette lighter
socket if you do not intend to use it for a long period of time.
z
p.19-43).

Advertisement

Table of Contents
loading

Table of Contents