Kyocera FAX System 10 Operation Manual page 205

Internet Faxing (i-FAX) > i-FAX transmission procedure
4
5
6
7
Configure the detailed settings.
1
[ ] of Mode > [Simple] or [Full]
2
[ ] of Via Server > [On] or [Off].
When this setting is set to [Off], transmission takes place by direct SMTP (not through an
e-mail server).
When this setting is set to [On], transmission takes place by the i-FAX method (through an
e-mail server).
NOTE
The settings are automatically configured based on the i-FAX transmission type that is
set in Command Center RX. When the transmission type is set to [Specify for Each
Destination], these settings can be configured.
Specifying the Destinations Conditions.
Select [Destination Condition].
The available settings are shown below.
Item
Resolution
Compression
Paper Size
Selecting the functions.
Fax transmission functions (page 3-18)
Grayed out items cannot be set.
Press the [Start] key.
When scanning finishes, transmission starts.
Specify the resolutions that can be received by the destination fax machine.
If you try to send an i-FAX using a prohibited resolution, it is automatically
changed to a permitted resolution and then sent.
• 200 × 100 dpi: Permitted (fixed)
• 200 × 200 dpi: Permitted (fixed)
• 200 × 400 dpi: Permitted or prohibited
• 400 × 400 dpi: Permitted or prohibited
• 600 × 600 dpi: Permitted or prohibited
To permit a resolution setting, press the key for that resolution so that it is
highlighted.
To prohibit a resolution, press the key again so that it is no longer
highlighted.
Select a suitable file format for the destination fax machine.
MH, MR, MMR or JBIG
Display the sending paper size for the destination fax machine. If you try to
send an i-FAX using a prohibited paper size, it is automatically changed to
a permitted paper size and then sent.
• A4/Letter: Permitted (fixed)
10-10
Description