Kyocera FAX System 10 Operation Manual page 179

Fax Settings > Default fax settings
Item
FAX Local FAX Number 1
Local FAX Number 2*
Dialing Mode (Port 1)
(Inch version only)
Dialing Mode (Port 2)*
(Inch version only)
Local FAX ID
ECM TX (Port1)
ECM TX (Port2)*
TX Start Speed (Port1)
TX Start Speed (Port2)*
* This function is displayed when 2 optional FAX Kits (Dual FAX option) are installed.
Register the local FAX number printed in the transmit terminal identification (TTI) area.
If you have already registered a number, the current registered number is
displayed.
This item is included in the Quick Setup Wizard.
Quick Setup Wizard (page 2-9)
Select the telephone line according to the type you are contracted with. Please note
that selecting a wrong telephone line will prevent you from sending fax.
Value: Tone(DTMF), Pulse(10PPS)
This item is included in the Quick Setup Wizard.
Quick Setup Wizard (page 2-9)
Register the local FAX ID.
This item is included in the Quick Setup Wizard.
Quick Setup Wizard (page 2-9)
NOTE: The Local FAX ID is used for transmission limit purposes.
Transmission Restriction (page 8-12)
Set whether ECM TX is performed.
ECM is a communication mode specified by the ITU-T (International
Telecommunication Union) that retransmits data when an error occurs. Fax
machines that have ECM mode check for errors as they communicate, preventing
distortion of the image due to noise on the line and other conditions.
Value: On, Off
NOTE
When there is a large amount of noise on the line, communication may take slightly
longer than when [Off] is selected.
Set the TX Start Speed.
When communication conditions are bad, the fax may not be transmitted correctly.
In that case, set a lower TX Start Speed.
Value: 9600bps, 14400bps, 33600bps
NOTE
Normally this should be used with the default setting.
8-9
Description