Stp Port Setting - Planet LRP-822CS User Manual

The page includes the following fields:
Object
 STP
 BPDU Forward
 Cost Method
 Force Version
 Configuration Name
 Configuration Revision

4.6.3 STP Port Setting

This page allows you to configure per port STP settings. The STP Port Setting screens in
The page includes the following fields:
Object
 Port Select
 External Cost (0 =
Auto)
 Edge Port
BPDU Filter

Description
Display the current STP state
Display the current BPDU forward mode
Display the current cost method
Display the current force version
Display the current configuration name
Display the current configuration revision
Figure 4-6-6 STP Port Configuration Page Screenshot
Description
Select port number from this drop-down list.
Controls the path cost incurred by the port. The Auto setting will set the path cost
as appropriate by the physical link speed, using the 802.1D recommended
values. Using the Specific setting, a user-defined value can be entered. The path
cost is used when establishing the active topology of the network. Lower path
cost ports are chosen as forwarding ports in favor of higher path cost ports. Valid
values are in the range 1 to 200000000.
Controls whether the operEdge flag should start as beeing set or cleared. (The
initial operEdge state when a port is initialized).
Control whether a port explicitly configured as Edge will transmit and receive
BPDUs.
146
User's Manual of LRP-822CS
Figure 4-6-6 & Figure 4-6-7 appear.