Canon 4K500ST User Manual page 43

3
Attach the Base bracket to the
projector
1 Remove the four screws at each
corner on top of the projector.
2 Install the attached M6 screws at
the four screw fastening
positions on the Base bracket.
Attach the included toothed lock
washer in the back-left position,
as shown at right.
4
Attach the anti-fall wire
Secure the terminal clamp with the
attached M4 screw at (A) on the
Base bracket.
• Make sure to fasten and tighten
the screw securely.
5
Pull cables out of the cable hole
in the ceiling
• As depicted in the diagram, let
cables pass through the hole on
ceiling-mount clamp.
• If cables are too thick, make a
hole at a different position than
the hole on the ceiling-mount
clamp, and let them pass through
the new hole.
6
Attach the Joint fitting to the
Ceiling-mount bracket
Secure the Ceiling-mount bracket
using the four M5 screws removed
during preparation.
Installation Procedure
Washer (Toothed Lock Washer)
43
A
Direction to the screen