Custom Color; Blackout; Reset - Chauvet COLORstrip User Manual

Custom Color

Blackout

Reset

Page 12 of 18
To custom mix a color, follow the instructions below:
1. Press <MODE> repeatedly until SYS or ACt shows on the display.
2. Use <UP> or <DOWN> to select ACt.
3. Press <ENTER>.
4. Use <UP> or <DOWN> to scroll through the menu until A021 shows on the display.
5. Press <ENTER> and r_ _ _ will show on the display.
6. Use <UP> or <DOWN> to increase or decrease the red value.
7. Press <ENTER> and G_ _ _ will show on the display.
8. Use <UP> or <DOWN> to increase or decrease the green value.
9. Press <ENTER> and b_ _ _ will show on the display.
10. Use <UP> or <DOWN> to increase or decrease the blue value.
11. Press <ENTER> and F_ _ _ will show on the display.
12. Use <UP> or <DOWN> to increase or decrease the strobe value.
·
Set F000 for no strobe.
·
Set F100 for sound-active strobe (Sensitivity knob must be turned up).
·
Set F001–F099 for auto strobe, from slow to fast.
13. Press <ENTER>. Repeat steps 3–12 as necessary.
To black out the COLORstrip/COLORstrip Mini, do the following:
1. Press <MODE> repeatedly until SYS or ACt shows on the display.
2. Use <UP> or <DOWN> to select ACt.
3. Press <ENTER>.
4. Use <UP> or <DOWN> to scroll through the menu until A000 shows on the display.
5. Press <ENTER>.
To reset the COLORstrip/COLORstrip Mini, follow the instructions below:
1. Press <MODE> repeatedly until SYS or ACt shows on the display.
2. Use <UP> or <DOWN> to select SYS.
3. Press <ENTER>.
4. Use <UP> or <DOWN> to select AAAd.
5. Press <ENTER>.
COLORstrip/COLORstrip Mini User Manual Rev. 1