Static Colors; Custom Color Mixing; Ir Mode - Chauvet EZ WEDGE Tri User Manual

Static Colors

Custom Color
Mixing

IR Mode

EZwedge™ Tri User Manual Rev. 1
To select a preset static color, do the following:
Press <MENU> repeatedly until C-- shows on the display.
1.
Press <ENTER>.
2.
Use <UP> or <DOWN> to select the desired preset color:
3.
·
C 1 - Red
·
C 2 - Green
·
C 3 - Blue
·
C 4 - Cyan
·
C 5 - Magenta
·
C 6 - Yellow
·
C 7 - White
Press <ENTER>.
4.
To custom mix a color, follow the instructions below:
Press <MENU> repeatedly until U-- shows on the display.
1.
Press <ENTER> and one of the following colors shows on the display: rXXX (red),
2.
gXXX (green), or bXXX (blue).
Press <ENTER> repeatedly to select the desired color.
3.
Use <UP> or <DOWN> to select the desired color value (0–255, 0–100%).
4.
NOTE: Selecting 0 will turn the color off.
Press <ENTER> to select color value and continue to the next color.
5.
Repeat steps 3 to 5 until you create your desired color.
6.
IR mode allows the product to be controlled with an infrared remote controller. The
IRC-6 can remotely set the product to various modes; adjust the color, speed and sensitivity;
and set the strobe.
The EZwedge™ Tri is compatible with the IRC-6 from Chauvet. To enable use with the IRC-6,
follow the instructions below:
Press <MENU> repeatedly until SET shows on the display.
1.
Press <ENTER> and On (turns on the infrared sensor) or
2.
OFF (turns off the infrared sensor) shows on the display.
Use <UP> or <DOWN> to select the desired option.
3.
Press <ENTER>.
4.
Page 17 of 22