Table of Contents
Advertisement
O
PERATION
Sound-Active Mode
To run the SlimPAR Q12 USB in sound-active mode, follow the instructions below:
1.
Press <MENU> repeatedly until Snd shows on the display.
2.
Press <ENTER>
3.
Use <UP> and <DOWN> to select a sound active program (Snd1 or Snd2)
4.
Press <ENTER>.
The product will only respond to low frequencies of music (bass and drums).
Sound Sensitivity
To set the sound sensitivity on the SlimPAR Q12 USB , do the following:
1.
Press <MENU> repeatedly until SenS shows on the display.
2.
Use <UP> or <DOWN> to increase or decrease the sound sensitivity, from (u 0–100).
3.
Press <ENTER>.
Preset Color Mode
To run the SlimPAR Q12 USB on a static color, follow the instructions below:
1.
Press <MENU> repeatedly until C-- shows on the display.
2.
Press <ENTER>.
3.
Use <UP> or <DOWN> to select a static color, from (C 1–18).
4.
Press <ENTER>.
Custom Color Mixing
To custom mix a static color, do the following:
1.
Press <MENU> repeatedly until U-- shows on the display.
2.
Press <ENTER> and one of the following will show on display.
•
r_ _ _ (red)
•
g_ _ _ (green)
•
b_ _ _ (blue)
•
A_ _ _ (amber)
3.
Press <ENTER> to cycle through the color settings.
4.
When the desired color shows on the display, use <UP> or <DOWN> to increase or decrease the
color value.
5.
Repeat steps 3 and 4 until the product outputs as desired.
Dimmer Speed Mode
To set the dimmer speed mode of the SlimPAR Q12 USB , follow the instructions below:
1.
Press <MENU> repeatedly until dIM shows on the display.
2.
Press <ENTER>.
3.
Use <UP> or <DOWN> to select:
•
dIM1 (fast)
•
dIM2 (medium)
•
dIM3 (slow)
•
or OFF
4.
Press <ENTER>.
SlimPAR Q12 USB User Manual Rev. 3
Page 11 of 17
Advertisement
Table of Contents
