Custom Color; Blackout; Reset - Chauvet COLORstrip User Manual

Custom Color

Blackout

Reset

Page 12 of 18
To custom mix a color, follow the instructions below:
1. Press <MODE> repeatedly until SYS or ACt shows on the display.
2. Press <UP> or <DOWN> repeatedly until ACt shows on the display.
3. Press <ENTER>.
4. Use <UP> or <DOWN> to scroll through the menu until A021 shows on the display.
5. Press <ENTER> and rxxx will show on the display.
6. Use <UP> or <DOWN> to increase or decrease the red value.
7. Press <ENTER> and Gxxx will show on the display.
8. Use <UP> or <DOWN> to increase or decrease the green value.
9. Press <ENTER> and bxxx will show on the display.
10. Use <UP> or <DOWN> to increase or decrease the blue value.
11. Press <ENTER> and Fxxx will show on the display.
12. Use <UP> or <DOWN> to increase or decrease the strobe value.
·
Set F000 for no strobe.
·
Set F100 for sound-active strobe (Sensitivity knob must be turned up).
·
Set F001–F099 for auto strobe, from slow to fast.
13. Press <ENTER>. Repeat steps 3 – 12 as necessary.
To black out the COLORstrip™, do the following:
1. Press <MODE> repeatedly until SYS or ACt shows on the display.
2. Press <UP> or <DOWN> repeatedly until ACt shows on the display.
3. Press <ENTER>.
4. Use <UP> or <DOWN> to scroll through the menu until A000 shows on the display.
5. Press <ENTER>.
To reset the COLORstrip™, follow the instructions below:
1. Press <MODE> repeatedly until SYS or ACt shows on the display.
2. Press <UP> or <DOWN> repeatedly until SYS shows on the display.
3. Press <ENTER>.
4. Press <UP> or <DOWN> repeatedly until AAAd shows on the display.
5. Press <ENTER>.
COLORstrip™ User Manual Rev. 6