Briggs & Stratton 86262GS Familiarization & Troubleshooting Manual page 107

Portable Generator Familiarization & Troubleshooting Guide
Section 4 • Generator Assemblies
The back of the connector plug has raised numbers that
identify its specific compartments (Figure 4.38).
Figure 4.38 — Connector With Raised Numbers
Raised Numbers
Raised Numbers
When you have installed the terminal connector into the
connector housing:
• Secure the power leads and connector housing to the
back of the power control panel (Figure 4.39).
Figure 4.39 — Connector Housing To Control Panel
Reinstall Generator Ground Wire
Remove any supporting blocks that might still be holding the
generator from resting in its cradle.
You should have retained two star washers and 1 wing nut
from disassembly.
• Install one star washer on the grounding lug.
• Then, the terminal lug for the grounding wire and the
other star washer.
Secure all of these with the "Wing nut" as shown in
Figure 4.40.
Figure 4.40 — Grounding Connection
Star Washer
105
Star Washer