Briggs & Stratton 86262GS Familiarization & Troubleshooting Manual page 105

Portable Generator Familiarization & Troubleshooting Guide
Section 4 • Generator Assemblies
With the harness in the grommet:
• Carefully start the rotor bearing into the rear bearing
carrier (Figure 4.31).
Figure 4.31 — Starting The Bearing Into Its Carrier
• Align the roll pin with the groove in the stator
laminations that is located at the 7 o'clock position
(Figure 4.32).
Figure 4.32 — Roll Pin To Stator Alignment
Stator Alignment Groove
Roll Pin
• Ensue that all the alignment marks are correct and seat
the rear bearing carrier on the stator.
When the rear bearing carrier is properly positioned on the
stator, the inner flange of the carrier will mount directly
against the actual laminations of the stator without any gap
inside the flange of the carrier
(Figure 4.33).
Figure 4.33 — Bearing Carrier and Flange
• All the alignment pins and notches should be in their
proper orientation.
• All the assembly components will be in full contact at
each of their mating surfaces.
When you are satisfied that all the above conditions have
been met, you are ready to install the stator bolts.
103