Briggs & Stratton 86262GS Familiarization & Troubleshooting Manual page 109

Portable Generator Familiarization & Troubleshooting Guide
Section 4 • Generator Assemblies
• Install the lock washers and nuts to the vibration mount
studs under the cradle frame arm
(Figure 4.45).
Figure 4.45 — Tighten Vibration Mounts
• Torque to specifications found in the appendix of this
guide.
Installing End Cover to Bearing Carrier.
The louvers on the end cover should be facing in towards
the generator as shown in Figure 4.46.
Figure 4.46 — Installing End Cover
• Ensure that the louvers are up as shown.
• Place the tab at the top of the cover over the grommet.
• Install the cover with the screws you retained from
disassembly.
• Torque to specifications found in the torque chart in
the appendix of this guide.
• Reinstall spark plug into cylinder head.
• Install spark plug lead.
• Start and test unit.
107