Briggs & Stratton 86262GS Familiarization & Troubleshooting Manual page 108

Installing the Brush Assembly
Figure 4.41 shows the brush assembly with its terminal wires
installed.
Figure 4.41 — Brush Assembly With Wire Terminals
Towards The Engine
#2
Note:
The brush housing has an index tab that
should be installed towards the engine.
With the index tab facing as shown:
• DPE wire #2 is positioned on the upper tang of the
brush housing.
• DPE wire #6 is positioned on the lower tang.
• Carefully work the brush assembly into its mounting
while taking care to position the wires as shown in
Figure 4.42 and tighten screws "finger-tight."
Figure 4.42 — Brush Holder Mounting
Index Tab
#6
Portable Generator Familiarization & Troubleshooting Guide
• Torque mounting screws (Figure 4.43) to specifications
in the torque chart found in the appendix of this guide.
Figure 4.43 — Torque Brush Holder Assembly
Install Vibration Mounts to Cradle
At this point the generator should be resting in its cradle.
The mounting lugs should be through their holes in the
cradle frame (Figure 4.44).
Figure 4.44 — Generator Vibration Mounts
106
Section 4 • Generator Assemblies