Briggs & Stratton 86262GS Familiarization & Troubleshooting Manual page 116

Power Harness Cable
• Reinstall the power harness cable connector as shown
in Figure 4.65.
Figure 4.65 — Install Power Harness Cable
• Connect the other end of the cable to the back of the
control panel (Figure 4.66).
Figure 4.66 — Connect Cable to Control Panel
Portable Generator Familiarization & Troubleshooting Guide
• Reinstall capacitor and connect terminal ends as shown
in Figure 4.67.
Figure 4.67 — Install Capacitor
• Check all connections and install the access cover with
the louvered half down as shown in
Figure 4.68.
Figure 4.68 — Install Access Cover
• Reinstall access cover with the hardware you retained
from disassembly.
• Insure that there are no obstructions to the rotation of
the rotor.
• Reinstall the sparkplug lead.
• Start and test unit.
114
Section 4 • Generator Assemblies