Sincro® Wound Generators; Disassembly - Briggs & Stratton 86262GS Familiarization & Troubleshooting Manual

Portable Generator Familiarization & Troubleshooting Guide
Section 4 • Generator Assemblies
DANGER:
Before servicing any Sincro
equipment, always remove the spark plug lead.
Unintentional ignition can cause severe personal
injury.

Disassembly

Removing Spark Plug Lead
• Remove the spark plug lead as illustrated in
Figure 4.47 and Figure 4.48.
Figure 4.47 — Sincro® Wound Generator
Access
Cover
Figure 4.48 — Disconnect Spark Plug Lead
Spark Plug
Lead
SINCRO® WOUND GENERATORS
®
Spark Plug
Lead
Sincro
Generator
Removing Sincro® Access Cover
• Remove the four screws holding the access cover to
the end of the sincro-generator (Figure 4.49).
Figure 4.49 — Sincro® Access Cover
Cover Screw
This exposes the components shown below in
Figure 4.50.
Figure 4.50 — Sincro® Components And Connections
Spade
Connector
A visual inspection of this area can reveal both mechanical
problems as well as problems with wiring connections.
109
Harness
Connector
Capacitor
Bearing
Carrier