Canon laser Shot LBP 3300 Getting Started Manual page 47

8
Connect the LAN cable.
Connect a LAN cable that is compatible with the LAN connector of the network
board according to the network.
9
Connect the power cord.
10
Plug the power plug into the AC power outlet.
11
Connect the USB cable as needed.
12
Press " " of the power switch to turn the printer ON.
13
Make sure that the LNK indicator (green) on the network
board is on.
If the network board is connected by 10BASE-T, the board is working properly
when the LNK indicator is on.
If the network board is connected by 100BASE-TX, the board is working properly
when the LNK indicator and 100 indicator are on.
((A): ERR Indicator (B): LNK Indicator (C): 100 Indicator)
(A)
(B)
(C)
If the network board is not working properly, turn the printer OFF, and then check
the LAN cable connection, hub performance, and network board installation. If
the network board does not operate properly even after turning the printer ON,
see "Chapter 4 Troubleshooting" in
14
Close the expansion slot cover.
Network Guide.
CD-ROM
Step
6
47