Removing The Packing Materials - Canon laser Shot LBP 3300 Getting Started Manual

Installation Space
The dimensions of each part, foot positions, and the space required for using
the printer with the paper feeder installed are indicated in the following
figures:
•
Dimensions of the Printer
Output selection cover
Front Surface
Expansion
slot cover
Paper cassette
383.5 375.7
•
Required Peripheral Space
Front Surface
1063.7
500
Paper cassette
Output selection cover
•
Foot Positions of the Paper Feeder
26.7
Front Surface
26.7
The front feet are 7.8 mm high and their top surface is 12 mm square.
The rear feet are 7.8 mm high, the left top surface has a rectangular shape of
21.7 mm x 40 mm, and the right top surface is 31.7 mm x 40 mm and is L-shaped.
(mm)
Front cover
88 114.2
(mm)
Front cover
100
294 40.3 (mm)
293.8 40.5

Removing the Packing Materials

The paper feeder is provided with tape and a packing material to be protected
from excessive vibrations and shocks during delivery. Remove the tape and
packing material before installing the paper feeder on the printer.
IMPORTANT
•
If there is any packing material remaining inside the paper feeder, this may
result in misfeeds or damage to the printer when operating the printer. Be
sure to remove all the packing materials following the procedure.
•
The removed packing materials are required when transporting the printer
for relocation or maintenance. Keep them where they will not get lost.
NOTE
The packing materials may be changed in form or position to be placed, or
may be added or removed without notice.
1
Pull out the paper cassette.
Step
6
37