Blade Stops Turning; Tools Needed - MK Diamond Products HD-101R Pro24 Owner's Manual

HD-101R Pro24

BlaDe SToPS TURninG

(A)
Allow the motor to cool and
depress motor Overload
Reset Switch. If motor does not
start, go to Step B.
noTe:
Verify circuit breaker at least 20 amps - if not, move to 20-amp circuit.
Verify circuit breaker is not tripped. If tripped, reset.
Check power source voltage is 120V - if not 120V, move to another circuit.
BlaDe aliGnMenT PRoCeDURe
The Movable Cutting Table of the MK-101 may become misaligned with the Cutting Head of the Tile
Saw over time. Should misalignment occur, perform the following steps to realign the Tile Saw.
noTe: If alignment problems are the result of a warped blade, a bent frame or bent support
arm, or, if alignment is off by more than 1/8-inch, contact the MK Diamond Service Center –
(800) 474-5594

ToolS neeDeD

(A)
Combination square (square)
12-inch or greater. 1/2-inch
Wrench or MK Triple Hole Box
Wrench and MK Open
End Wrench.
(B)
Verify all plugs fully installed.
Check Ground Fault Circuit
Interrupter
43
TRoUBleSHooTinG