HD-101R Pro24
aSSeMBlY
Diamond Blade installation
noTe: When installing the Retaining Nut, do not "cross-thread" and DO NOT over tighten.
Shaft Lock
Pushbutton
(A)
(B)
(C)
Position Movable Cutting Table
Locate the Shaft Lock push
Depress and hold the Shaft
to the front of the saw and
button on the underside
Lock pushbutton and remove
raise the Blade Guard by
of the Cutting Head.
Retaining Nut and Outer Flange
loosening the wingnut.
using the Blade Wrench.
(D)
(E)
(F)
Install Diamond Blade
Verify the Blade is seated on
Install Retaining Nut and Outer
onto Blade Shaft.
the Blade Shaft and direction
Flange, depress and hold the
of rotation is correct.
Shaft Lock pushbutton
and tighten Retaining Nut.
24