Safety Label Locations; Lockout - MK Diamond Products HD-101R Pro24 Owner's Manual

HD-101R Pro24

SaFeTY laBel loCaTionS

Safety labels contain important safety information. Please read the information contained on each
safety label. These labels are considered a permanent part of your saw. If a label comes off or
becomes hard to read, contact MK Diamond or your dealer for a replacement.
CAUTION
!
Receptacle is for
water pump only.
125V, .6 amps max.
Label A
CAUTION
!
This saw is to be used
with a Ground Fault
Circuit Interrupter.
Label B
FOR INFORMATION ON
SERVICE OR
WARRANTY
PLEASE CALL
1-800-474-5594
Label C
For manuals and parts
lists scan the QR code
with your smart phone
Label G
Decal/label location
A
B
C
D
E
F
G
loCK oUT MeTHoD
In order to help prevent accidental starting and to help make
your work area "kidproof," this machine is provided with a
means to deactivate the functioning of the motor switch. The
switch is equipped with a lockout tab that can be used with a
lock to prevent movement of the switch. With the switch un-
able to move the motor cannot be turned on. Removing the
lock reactivates the switch.
Tile Saws
!
Grinding/cutting/drilling of masonry, concrete, metal and other materials with silica in
their composition may give off dust or mists containing crystalline silica. Silica is a basic
component of sand, quartz, brick clay, granite and numerous other minerals and rocks.
Repeated and/or substantial inhalation of airborne crystalline silica can cause serious
or fatal respiratory diseases, including silicosis. In addition,California and some other
authorities have listed respirable crystalline silica as a substance known to cause cancer.
WARNING
!
For Your Own Safety Read Instruction Manual
Before Operating Saw.
Wear Eye Protection.
Disconnect Saw Before Servicing, when Changing
Cutting Wheels and Cleaning.
Use Tool Only with Smooth Edge Cutting Wheels
Free of Openings and Grooves.
Replace Damaged Cutting Wheel Before Operating.
Do Not Fill Water Bath Above Water Fill Line.
See Manual for Pump Replacement.
NOTICE
!
Most Motor Problems are caused by improper
voltage and extension cords. Cord should be
one-piece and short as possible. Cord
selection should match the following table.
1-2 H.P.
115v 230v
25' 100' Max. Cord Length No. 12 Wire
50' 150' Max. Cord Length No. 10 Wire
75' 250' Max. Cord Length No. 8 Wire
Label F
Tile Master Label Sheet Part#166012
Motor - Back
Motor - Front
otor -
M Side
Cutting Head - Front
Motor – Side
Motor - Back
Motor - Back
WARNING
Label D
C
Label E
Description
Caution - Receptacle is for Water Pump Only
Caution - Use with GFCI outlet only
Service/ Warranty
Warning - Silica Warning
Warning - Read Owners Manual
Notice - Voltage/extension cords
Owner's Manual
19
SaFeTY
G
D
B
F
E
A