Blade Stops Turning - MK Diamond Products HD-101R Pro24 JCS Owner's Manual & Operating Instructions

HD-101R Pro24-JCS

Blade Stops Turning

(A)
Allow the motor to cool and
depress motor Overload
Reset Switch. If motor does not
start, go to Step B.
(D)
Verify circuit breaker is not
tripped, if it is tripped – reset the
circuit breaker once, If circuit
breaker not tripped, go to Step f.
(B)
Verify all plugs are fully
installed. Check to see if the
Ground Fault Circuit Interrupter
(GFCI) is tripped*. If not tripped, or
if a re-trip occurs, go to Step D.
(E)
Check power source voltage is
120V, if it is not 120v –
move to another circuit.
46
TROUBLESHOOTING
(C)
Verify the circuit breaker is at
least 20 amps – if not, move to
a 20-amp circuit. If circuit is 20
Amps or greater, go to step E.