Blade Stops Turning - MK Diamond Products MK-212 series Owner's Manual

MK-212 SAW
CUTTING HEAD DOES NOT MOVE CORRECTLY
(A)
Check that Guide Rail and Cutting
Head is clean and clean if dirty.

BLADE STOPS TURNING

(A)
Check the ON/OFF Switch is in
the ON position.
(D)
Verify the circuit breaker is at least
20 amps – if not, move to 20 amp
circuit.
(B)
Lubricate the Guide Rail and
Cutting Head.
(B)
Verify all plugs are fully connected.
(E)
Verify circuit breaker not tripped; if
it is tripped, reset it once only.
34
MAINTENANCE
(C)
Check the Cutting Head
alignment.
(C)
Check to see if the Ground Fault
Circuit Interrupter (GFCI) tripped.
(F)
Check power source voltage
is 115v – if not 115v, move to
another circuit.