Blade Stops Turning; Blade Will Not Cut Properly - MK Diamond Products MK-5005S Owner's Manual

MK-5005S

Blade Stops Turning

(A)
Verify the motor ON/OFF
switch is in the ON position
(D)
Verify the circuit breaker is at
least 30 amps - if not, move to
30-amp circuit

Blade will Not cut Properly

(A)
Check for smoothness
or "glazing"
(B)
Verify the MK-5005S is con-
nected to the power source
(E)
Verify circuit breaker is not
tripped, if tripped, reset once
(B)
Check for proper rotation
34
TRoUBlESHooTING
(C)
Allow motor to cool and
depress the motor Overload
Reset Switch
(F)
Check power source voltage
is 230V - if not 230V, move to
another circuit
(C)
Ensure Blade Core is not bent.
Verify blade is correct for
material being cut