Advertisement
REMOTE HANDSET
The remote handset will permit you to access remotely all the functions found on the front
panel of the unit: VOLUME UP or DOWN, MUTE ON or OFF, DIRECT ACCESS for all the
INPUTS and TAPE monitor. In addition to all these functions, the button marked DISPLAY will
permit you to select through the four Display modes on the unit.
PLEASE NOTE that the DISPLAY function can only be activated through the remote handset.
To access the batteries, unscrew the back plate of the remote handset (see fig. 2, page 14)
BALANCE CONTROL (ON REMOTE HANDSET ONLY):
The balance control found on the remote handset only permits equal output of each channel
in the center (00.0) position without additional loading to the signal. When shifted to the left or
right, it merely attenuates the opposite channel. When operating the balance control, the display will
show < - -. - if the balance control is shifted to the left or - -.- > if the balance control is shifted to the
right. The amount of attenuation will be show on the DIGIT display in increments of 0.5 up to20.0.
The opposite channel now gives out no signal since the balance is completely shifted to one side.
DISPLAY (ON REMOTE HANDSET ONLY)
Pressing the DISPLAY button on the remote handset (see fig. 1, page 14) allows you to
control the brightness of the display. There are 3 levels of brightness; Display On, Display Medium
On, Display Low On or Display Full Off. Repeated pressing of the DISPLAY button will cycle
through the four modes, from Display Full On to Display Full Off. Pressing DISPLAY when the
display is at Full Off will cause the display to go back to Display Full On.
12
C-303 Issue 1 July '98
Advertisement
