Master/Slave Mode - Chauvet Wedge Tri User Manual

Master/Slave
Mode
Wedge™ Tri User Manual Rev. 3
The Master/Slave mode allows a single Wedge™ Tri (the "master") to control the actions
of one or more Wedge™ Tri units (the "slaves") without the need of a DMX controller.
The master will be set to operate in either Automatic or Sound-Active mode, while the
slaves will be set to operate in Slave mode. Once set and connected, the slaves will
operate in unison with the master.
Configure the units as indicated below.
Slaves:
1. Press <MENU> repeatedly until any DMX personality shows on the display.
2. Press <ENTER> to accept.
3. Set the DMX address to d 1.
4. Connect the DMX input of the first slave to the DMX output of the master.
5. Connect the DMX input of the subsequent slaves to the DMX output of the previous
slave.
6. Finish setting and connecting all the slaves.
Master:
1. Set the master to operate in either Automatic or Sound-Active mode.
2. Make the master the first unit in the DMX daisy chain.
·
Configure all the slaves before connecting the master to the DMX daisy chain.
·
Never connect a DMX controller to a DMX string configured for master/slave
operation because the controller may interfere with the signals from the
master.
·
Do not connect more than 31 slaves to the master.
Page 17 of 20