Table of Contents
Advertisement
Master/Slave Mode
The Master/Slave mode allows a single Intimidator Beam 355 IRC product (the "master") to control the
actions of one or more Intimidator Beam 355 IRC products (the "slaves") without the need of a DMX
controller. The master product will be set to operate in either Stand-Alone mode or with the IRC-6, while
the slave products will be set to operate in Slave mode. Once set and connected, the slave products will
operate in unison with the master product.
Configure the products as indicated below.
Slave products:
1.
Press <MENU>.
2.
Use <UP> or <DOWN> to select Run Mode.
3.
Press <ENTER>.
4.
Use <UP> or <DOWN> to select Slave.
5.
Press <ENTER>.
6.
Use <UP> or <DOWN> to select from Slave1, Slave2, Slave3, or Slave4.
•
Select Slave1 for 100% synchronized actions.
•
Select Slave2, Slave3, or Slave4 for a delayed show, creating a wave effect.
7.
Connect the DMX input of the first slave product to the DMX output of the master product.
8.
Connect the DMX input of the subsequent slave products to the DMX output of the previous slave
product.
9.
Finish setting and connecting all the slave products.
Master product:
1.
Set the master product to operate in Stand-Alone mode or with the IRC-6.
2.
Make the master product the first product in the DMX daisy chain.
•
Configure all the slave products before connecting the master to the daisy chain.
•
Never connect a DMX controller to a DMX string configured for Master/Slave
operation because the controller may interfere with the signals from the master.
•
Do not connect more than 31 slaves to the master.
Zero Adjust Mode
The Intimidator Beam 355 IRC contains a passcode protected mode which allows the user to calibrate and
adjust several of the product's operating parameters.
In order to access this mode, do the following:
1.
Press and hold <MENU> for at least 3 seconds.
2.
Use <UP> (increases the selected value) and <DOWN> (selects the next value) to enter the
passcode: 2323.
3.
Press <ENTER>.
In this mode, the starting positions for the following can be adjusted:
To adjust the starting position of one of these parameters, follow the instructions below:
1.
Access the Zero Adjust mode.
2.
Use <UP> or <DOWN> to select the parameter to be adjusted.
3.
Press <ENTER>.
4.
Use <UP> or <DOWN> to increase or decrease the selected value, from 000–255.
5.
Press <ENTER>.
Page 16 of 20
P
D
ARAMETER
EFAULT
PAN
147
TILT
128
COLOR
128
GOBO
128
PRISM
128
DIMMER
070
F
UNCTION
Pan motor
Tilt motor
Color wheel
Gobo wheel
Prism assembly
Shutter assembly
Intimidator Beam 355 IRC User Manual Rev. 1
O
PERATION
Advertisement
Table of Contents
