Ir Leds - Qvis IPTZ-P400-10X User Manual

3.3 IR LED
MAIN MENU
INFORMATION
[ CAMERA ]
IMAGE
MOTION
RESTART
DEFAULT
EXIT
CAMERA
LANGUAGE
[ IR LED ]
IDLE
MASK
ALARM
PTZ DISPLAY
BACK
EXIT
IR LED
[ILLUMINATION
MODE
SENSITIVITY
SWITCH DELAY
NEAR POWER
FAR POWER
NEAR COMPENSATION
BACK
EXIT
© Copyright Qvis ®. All documentation rights reserved.
User can configure the IR LED working mode
via the 'IR LED' options within the 'Camera'
menu. The configuration options are as
follows:
1. Illumination:
Device can automatically adjust luminance
according to surrounding environment.
2. Mode:
Auto: IR LED automatically turns off or on
according to the light levels.
Open: IR LED forced to be continuously be
turned on.
Close: IR LED forced to be continuously be
turned off.
3. Sensitivity:
When IR LED mode is set to auto, the
smaller the number, the lower the light
level of the environment will be when the
34]
IR LED on.
AUTO
4
4. Switch delay: Filter handover delay time
is 1-60s.
5
10
5. Near power: 1-10 adjustable
10
2
6. Far power: 1-10 adjustable
7. Near Compensation: Set near
compensation rate from 0-3, the IR LED
near light will turn on when environmental
light levels are low in the foreground.
39