Fluke 8845A Manual page 79

Command Name
*IDN? Identification Query
*OPC Operation Complete
Command
*OPC? Operation Complete
Query
*RST Reset
*SRE <value>
Service Request
Enable
*SRE?
Service Request
Enable Query
*STB? Read Status Byte
*TRG Trigger
*WAI Wait-to-continue
[1] The user defined IDN 8845A/46A command identification response will set the *IDN? Indentification query
response for both 8845A/46A and Fluke 45 modes of operation. IDN is an "8845A/46A" only command.
Table 20. IEEE-488.2 Common Commands (cont.)
Meter returns the identification code of the meter as four fields
separated by commas. These fields are: manufacturer
("FLUKE"); model ("45"); seven-digit serial number; version of
main software and version of display software.
FLUKE, 45, 9080025, 2.0, D2.0)
Meter sets the Operation Complete bit in the Standard Event
Status Register when parsed.
Meter places an ASCII "1 " in the output queue when parsed.
Meter performs power-up reset, except that the state of IEEE-
488 interface is unchanged, including: instrument address,
Status Byte, and Event Status Register.
Sets the "Service Request Enable Register" to <value>, an
integer between 0 and 255. The value of bit six is ignored
because it is not used by the Service Request Enable
Register.
Note that <value> is an integer whose binary equivalent
corresponds to the state (1 or 0) of bits in the register. If
<value> is not between 0 and 255, an Execution Error is
generated.
Meter returns the <value> of the Service Request Enable
Register (with bit six set to zero); <value> is an integer whose
binary equivalent corresponds to the state (1 or 0) of bits in
the register.
Meter returns the <value> of the Status Byte with bit six as the
Master Summary bit.
<value> is an integer whose binary equivalent corresponds to
the state (1 or 0) of bits in the register.
Causes the meter to trigger a measurement when parsed.
Command required by IEEE-488.2 standard. Non-operational
in Fluke 45 Dual Display Multimeter. Command accepted but
has no effect.
FLUKE 45 Command Emulation Summary
Description
[1]
(example:
Remote Operation
69