Fluke 8845A Manual page 109

Table 33. Execution Error Codes and Descriptions (cont.)
Error Code Error Text
421 Instrument configuration
invalid
422 Instrument configuration
parameter
426 Instrument configuration
load
510 CCO Name bad
511 RS-232
framing/parity/overrun
error
512 RS-232 fatal error
513 RS-232 Configuration
error
514 Command allowed only
with RS-232
520 Command line too long
521 Input buffer overflow
522 Output buffer overflow
531 Insufficient memory
550 Command not allowed
in local
1000 Unknown function
1001 Unknown range
1002 Unknown CCO
1003 Can't set NPLC
1004 Can't set trigger
1005 Can't get DCV Gains
1006 Line Freq High
1007 Line Freq Low
1008 Write CCO failure
65535 Unknown
Description
Tried to set invalid state.
Invalid parameter.
Instrument configuration load failed.
CCO constant name is bad.
A fatal error occured opening the serial port.
A fatal error occured while configuring the serial port.
Commands which are only allowed with the RS-232/Ethernet
interface are SYSTem:LOCal, SYSTem:REMote, and
SYSTem:RWLock, or in Fluke 45 emulation mode the
commands are LOCS, REMS, RWLS, and LWLS.
The command line exceeded 350 characters.
There is not enough memory to store the requested number of
readings in internal memory using the INITiate command. The
product of the sample count (SAMPle:COUNt) and the trigger
count (TRIGger:COUNt) must not exceed 5,000 readings.
The multimeter received a READ? command while in the local
mode. For RS-232 operation, the SYSTem:REMote command
should always be executed before sending other commands
over the interface.
Unknown Function Selection.
Unknown Range Selection.
Unknown Calibration Constant.
Illegal/Unknown NPLC Selection.
Illegal/Unknown TRIGGER Selection.
Cannot get 1V/10V DC linearization constants.
AC Line frequency too high.
AC Line frequency too low.
Calibration Constant write failed.
Unknown Error.
Remote Operation
Error Codes
99