Fluke 8845A Manual page 55

Query VOLT:RANG:AUTO?
[SENSe:]<function>:RESolution(?) <n>
Description Sets the resolution according to the value supplied for n, for the Meter
function specified in the variable <function>. Resolution is specified in the
same units as the function. i.e., volts for the volts ac and dc functions. This
setting is stored in volatile memory
For functions that do not have selectable ranges, an error is returned when
using frequency, period, temperature, diode test, or continuity as the
function in the RESolution command.
Parameters <n>
Examples VOLT:RES 1e-4
CURR:AC:RES 1e-8
Query VOLT:RES?
VOLT:RES? MIN
[SENSe:]<function>:NPLCycles(?) <n>
Description Sets the Meter's integration time for the function specified in <function>,
based on the number of power line cycles. This setting is stored in volatile
memory
This command is only valid for dc voltage, dc current, temperature, and
resistance (2-wire and 4-wire) functions.
Parameters <n>
Examples VOLT:DC:NPLC .2
Query VOLT:NPLC?
CURR:NPLC? MIN
[SENSe:]TEMPerature:[TRANsducer:]<subfunction>:R0(?) <n>
Description Sets the resistance at zero degrees C specified by <n> for the R0 parameter
of the temperature function. This setting is stored in volatile memory.
Parameters <subfunction> =
<n>
Examples TEMP:RTD:R0 120
Query TEMP:RTD:R0?
Returns the dc volts autorange state. A zero
means off and a one means on.
= resolution value Desired resolution in volts, amps, ohms, or
farads.
MIN Highest resolution
MAX Lowest resolution
Sets the dc volts resolution to 100 μV.
Sets the ac amps resolution to 10 nA.
Returns the set resolution for dc volts.
Returns the minimum resolution of the dc volts
function.
= 0.02 to 100 sets integration time to a preset value of a
power line cycle (0.02, 0.2, 1, 10, and 100)
MIN 0.02 NPLC
MAX 100 NPLC
Sets the dc volts integration time to 0.2 of a
power line cycle.
Returns the integration time for dc volts.
Returns the minimum integration time for the dc
current function.
RTD 2-wire RTD
FRTD 4-wire RTD
Resistance at 0 °C
= 0 to 1010
Sets the resistance at 0 °C to 120 ohms.
Returns the set resistance at 0 °C.
Remote Operation
Supported SCPI Commands
45