Wiring Connections - Dynasty Spas Spa & Hot Tub 2016 Operator's Manual

Powering up the unit
Make sure all accessories are linked to the bonding connector and connected
to the pack.
Make sure the spa pack door is closed.
Turn on the breaker.
in.xm.ce
It's important to specify the phase configuration setting at the power supply:
Single-phase (1P), Dual- phase (2P) or Three-phase (3P).
Bonding lug
Press select button to select the proper phase configuration setting.
The in.scan display will show "x P", with "x" representing the number of
phases of the electric power system.
Make sure all accessories
RCD
are linked to the bonding
1 X 32 A
connector and connected
to the pack.
2 X16 A
3 X 16 A
Make sure the spa pack door is
closed.
Turn on the breaker.
It's important to specify the
phase configuration setting
at the power supply : Single-
phase (1P), Dual- phase (2P) or
Three-phase (3P).
Use change button to go from one parameter to the next.
Press select button again to make the correct selection.
All receptacles will match the corresponding female connection on the spa
pack.
No connectors should remain unplugged. Use blank plugs to fill unused
Press Select button to select
connectors.
the proper phase configuration
setting.
Sec1:22
The in.scan display will show
"x P", with "x" representing
the number of phases of the
(XM2) WIRING CONNECTIONS
in.xm.ce
Bonding lug
Bonding lug
Make sure all accessories
are linked to the bonding
connector and connected
to the pack.
Make sure the spa pack door is
closed.
Turn on the breaker.
It's important to specify the
phase configuration setting
at the power supply : Single-
phase (1P), Dual- phase (2P) or
Three-phase (3P).
Press Select button to select
Br
the proper phase configuration
1 P
setting.
2P
The in.scan display will show
3 P
"x P", with "x" representing
the number of phases of the
electric power system.
RCD
1 X 32 A
2 X16 A
3 X 16 A
Use Change button to go from
one parameter to the next.
Press Select button again to Spa Operator's Guide
make the correct selection.
All receptacles will match
Press Select button to select
the proper phase configuration
setting.
The in.scan display will show
"x P", with "x" representing
the number of phases of the
electric power system.
RCD
1 X 32 A
2 X16 A
3 X 16 A
Use Change button to go from
one parameter to the next.
Press Select button again to
make the correct selection.
All receptacles will match
the corresponding female
connection on the spa pack.
Br
No connectors should remain
1 P
unplugged. Use blank plugs to
fill unused connectors.
2P
3 P
Use Change button to go
one parameter to the nex
Press Select button again
make the correct selectio
All receptacles will match
the corresponding female
connection on the spa pa
Br
No connectors should re
1 P
unplugged. Use blank pl
fill unused connectors.
2P
3 P
powering up the unit
pow