SET-UP & DELIVERY GUIDELINES
Electrical requirements
Electrical Requirements
• (NA) Your 220 Volt spa pack will require a double pole 60 amp
dedicated GFCI, ground fault circuit breaker. (refer to page 25)
• (EU) Your 230 Volt spa pack will require a dedicated
breaker. (refer to page 20-21)
Caution: Connect only to a circuit protected by a class A ground fault
circuit interrupter.
• Extension cords are not to be used in conjunction with operation of
the spa. Low voltage damage could result, which is not covered by
warranty.
• If you have any doubts, have your electrical system checked by a
licensed electrician.
• Use copper conductors only.
Warning tag
3" (7.62 cm) Concrete pad
It is the customer's responsibility to acquire necessary permits and
to arrange for installation and hook up of the electrical power by a
licensed electrician.
Sec1:29
Disconnect switch
Service panel
NOTE!
Spa Operator's Guide
Disconnect must be located in
sight and no closer than 5 feet
(1.52m) from inside walls of the
spa.