While Operating The Machine - Toro Groundsmaster 360 Service Manual

While Operating the Machine

Before starting the machine
Before stopping the machine
Safety: Safety Instructions
•
Sit on the seat when starting and operating the machine.
•
Anytime you park the machine (short or long term), lower the cutting deck
to the HOC pin.
When you lower the cutting deck to the HOC pin, the pressure
from the lift circuit releases and prevents the cutting deck from
accidentally lowering.
•
If you park the machine on a slope, block or chock the wheels.
1. Set the parking brake.
2. Ensure that the traction pedal is in the N
is in the O (disengaged) position.
FF
Note: If the machine is on any type of slope, it may move when the parking
brake is released.
3. With the machine on a level surface after the engine is started, release the
parking brake and keep foot off the traction pedal. Ensure that the machine
does not move.
Note: If machine movement is evident, the traction linkage is adjusted
incorrectly; therefore, shut off the engine and adjust the traction linkage
until the machine does not move when the traction pedal is in the N
position; refer to Traction Linkage Assembly (page
The exhaust fumes are hazardous and have the potential of injury
or death.
Do not run the engine in a confined area without adequate ventilation.
Running the engine causes the engine, radiator, and exhaust system
to become hot. Touching a hot engine, radiator, or exhaust system
can burn you.
Do not touch the engine, radiator, or exhaust system while the
engine is running or soon after you stop it.
1. Ensure that the traction pedal is in the N
2. Lower and disengage the cutting deck and wait for all moving parts to stop.
3. Set the parking brake.
4. Shut off the engine and remove the key from the key switch.
IMPORTANT
EUTRAL
DANGER
CAUTION
EUTRAL
Page 1–4
position and the PTO switch
EUTRAL
4–89).
position.
Groundsmaster 360
16225SL Rev C