Bottom Cover - HP Spectre x360 Maintenance And Service Manual

Bottom cover

NOTE: The bottom cover spare part kit includes 4 rubber feet.
Description
In ash silver finish for use only on computers with model numbers 13-4100 through 13-4199
In natural silver finish for use only on computers with model numbers 13-4000 through 13-4099
Before disassembling the computer, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation,
turn the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
Remove the bottom cover:
1. Close the computer.
2. Turn the computer upside down with the front toward you.
3. Remove the two Torx5 T5M2.0×8.0 screws (1) and the six Torx5 T5M2.0×3.9 screws (2) that
secure the bottom cover to the computer.
4. Separate the rear edge of the bottom cover (1) from the top cover until it rests at an angle.
28 Chapter 5 Removal and replacement procedures
Spare part number
833711-001
801492-001