Smart Card Reader; Remove The Bottom Cover (See Bottom Cover; Remove The Battery (See Battery - HP mt45 Maintenance And Service Manual

Smart card reader

Table 6-11 Smart card reader and cable descriptions and part numbers
Description
Smart card reader
Smart card reader pass-thru board (for use in models without a smart card)
NOTE: This board provides cable pass-through capability for models without a smart card.
Smart card reader cable (available in Cable Kit)
Before removing the card reader, follow these steps:
1. Prepare the computer for disassembly
2. Remove the bottom cover (see
3. Remove the battery (see
Remove the smart card reader:
NOTE: Before you remove the smart card reader, make sure nothing (memory card or plastic insert) is
inserted in the reader.
1. Disconnect the system board cable from the connector on the smart card reader board (1).
2. Disconnect the touchpad cable from the ZIF connector on the smart card reader board (2).
3. Remove the three Phillips M2.0 × 2.0 screws (3) that secure the smart card reader to the computer.
4. Remove the smart card reader from the computer (4).
Reverse this procedure to install the smart card reader.
(Preparation for disassembly on page
Bottom cover on page
Battery on page 44).
32).
32).
Component replacement procedures
Spare part number
L62733-001
L62743-001
L64668-001 (Cable Kit)
57